Cutting discs are widely used in industrial processing. From the perspective of production technology, the process of cutting discs is not complicated, but if the production process is not rigorous enough, many problems will occur in later use. Common problems mainly include the following aspects.
1. Shaking hands. If the static balance of the cutting disc is unqualified during production, many problems will occur in later use. The most obvious is that when the cutting disc is running at high speed, the handle will vibrate, which will not only reduce the cutting efficiency and cause waste, but also affect production safety.
2. Film. The hardening temperature is low, the furnace or the kiln is too fast or the temperature difference is too large, and the hardening furnace exhaust is not good, etc., which will cause the cutting piece to appear soft. When the cutting disc is running at high speed, the problem of soft film will make the trajectory of the cutting disc unable to be in a straight line, and the cut material will appear oblique stubble, which cannot meet the processing requirements.
3. Cracks and broken. There are many reasons for this kind of problem, which may be the quality problem of the mesh, the amount of binder or the quality problem, or the temperature of the kiln is too low, etc. These reasons will cause the cutting disc to produce cracks when it is running at high speed. If the operation If the personnel are not properly protected, it will hurt people.
