In the process of using the belt, it is inevitable that there will be a problem of breakage. How to solve this problem?
1. The belt joint is not strong and cracked, and the quality control in production is strengthened to meet the needs of users.
2. The tension of the belt is too large, and the adjusted tension does not slip under the working load. The smaller the tension, the better.
3. When the belt is wrinkled or damaged at the time of transportation or installation, the quality of the appearance before installation should be checked, and the correct operation mode should be carried out when installing the machine.
4, the work pressure is too large, reduce the pressure
5. Cutting too deep, friction heat accumulation, reducing cutting depth or feed rate, or using coolant or cooling device
6. External debris enters between the belt and the roller or plate to remove debris. High-efficiency dust extraction is the best preventive measure.
7. The belt is over-vibrated, use low-hardness contact wheel to check the vibration of the machine or the quality of the belt.
8. The contact roller is tapered; the contact roller or graphite pad is not parallel to the base. The grinding roller removes the taper; reinstall and keep parallel
9. The machine is not working properly, the belt is broken by the travel switch. The maintenance equipment (special attention to the paper-based belt)
10. The difference between the thickness of the workpiece is too large or partially overlap the impact belt. Install the protective device for the overlapping plate and the oversized part.
